Hi
Picked this up a CRS226-24G-2S+RM a while back, been using it on and off but only put it back into use again recently. I'm not trying to do anything too strenuous, a bit of VLANing and QOS, but I'm continually confused by the multiple ways you can configure some of the options.
I've used the switch-VLAN config tabs rather than the interface-VLAN approach as I think this uses the h/w rather than in s/w. However , I'm struggling to get a Unifio wifi to work on this properly.
I want to allow 3 tagged vlans across the port its plugged into and tag any untagged ports onto a fourth VLAN. The latter works fine but I can't get the tagged packets to work. The ubiquiti device is setup the same as another which is working fine against a Dell switch. I'm a bit stumped - particularly as I am sure I had this setup working before.
Am I approaching this in the wrong way from what I have written i.e should i be defining a bridge device and using the int method? I can plonk down the config if it will help.
Picked this up a CRS226-24G-2S+RM a while back, been using it on and off but only put it back into use again recently. I'm not trying to do anything too strenuous, a bit of VLANing and QOS, but I'm continually confused by the multiple ways you can configure some of the options.
I've used the switch-VLAN config tabs rather than the interface-VLAN approach as I think this uses the h/w rather than in s/w. However , I'm struggling to get a Unifio wifi to work on this properly.
I want to allow 3 tagged vlans across the port its plugged into and tag any untagged ports onto a fourth VLAN. The latter works fine but I can't get the tagged packets to work. The ubiquiti device is setup the same as another which is working fine against a Dell switch. I'm a bit stumped - particularly as I am sure I had this setup working before.
Am I approaching this in the wrong way from what I have written i.e should i be defining a bridge device and using the int method? I can plonk down the config if it will help.