Thx for the replys,
it was my own, foult, sometimes you have to be a bit patiently.
you have to wait that the LED LE1 starts to blink, then the board is working.
Now all works fine.
Thx again
Andy
Hello thx for the fast answer,
i tried to shorten the pin 1+2 with an jumper, was the same didn't start.
I think yes that the PMBus is correct connected, i think you cant put it in in the wrong way.
i am at the moment at work, i will make dome pictures when iam at home.
Hello i bought that JB3 Board for my SC847E16-RJBOD1.
But i cant turn on my SC847 with the new JB3. if iam connect my old JB2 all works fine.
i tried the control panel connector in both directions, but normaly the red side identicate the powerside,
Any help or ideas?
Thx Andy
PS Sorry for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.