I have a 6036 (from mellanox I believe) and I am trying to set the fan speeds. I can get PS1 to set, but the fans won't set.
I am running 3.6.8012 and have used the fae commands.
(config) # fae mlxi2c set_fan /FAN1/FAN 1 30
Aug 17 20:47:54 INFO LOG: Initializing SX log with STDOUT as...
I was wondering if the DCS-7050S supports just plain SFPs? I have some 1g copper that I would like to plug into it if it does.
Also, anything I should know about for those switches? I am reading I can upgrade the boot flash to 4g, and the ram to 16g for pretty cheap, so those seem like no...
Thank you for the article, It will be helpful in the long term. In the short term though, if I connect a breakout cable to the 6036 so far all I see are breakout cables that are qsfp+ to sfp+ male to male. I need something on the sfp+ side that I can convert the male to a female rj45 connection...
Thank you so much for the info!! That helps a ton.
Unfortunately I do need some 1g rj45 connections so I am kind of stuck with another switch. I am looking for something that would convert the sfp+ male connection to a copper rj45, but haven't found that yet. If I can do that, then there's...
Good morning,
Sorry if this is a really dumb question, but I was wondering if it's possible to connect a mellanox 6036 switch to an ethernet switch? I have been trying to read through all the posts about the switches, and there is conflicting info.
I read that the 6036s have a VPI system...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.