Recent content by lawrence1986

i did mine in the Gui

can you send me a screen shot or something so i can copy your setting if you dont mind?

is that how i was suppose to do flow contral on this switch

Well, you were on to something. I was on Person 9 firmware, so I had to go to port settings to find the port I wanted, and where it says flow counter, I had to set it to none. than back to honor only, im going to restart the switch to make sure the settings are set and stay set althought these...

so what i did to make it work was sign in to the web gui on Version 9, go to port settings, click edit and i had to change port speed to 10gb full and flow contral to none

Well, you were on to something. I was on Person 9 firmware, so I had to go to port settings to find the port I wanted, and where it says flow counter, I had to set it to none. than back to honor only, im going to restart the switch to make sure the settings are set and stay set althought these...

the issue is the sfp+ port I am trying to use isnt working; it should be working; its supposed to be compatable MikroTik S+RJ10

For the ICX7xxx series, no actual licenses are required. Around the release of FastIron v8060, they enabled honor-based licensing. This means you can simply install and unlock a valid license yourself with the license install command. That's it! Congratulations Ruckus, you did it. Just be sure...

i cant even get my 7250 to work with these sfp+ ports https://www.amazon.com/dp/B078SNK1MY?psc=1&ref=ppx_yo2ov_dt_b_product_details which are mikrotik.

UPDATE! I bought these, the MikroTik S+RJ10, but they do not work. I was wondering if it would affect the 10GB license. firmware is 09.0.10h

this is what i did do i need to do anything its a 48 port non poe enable erase startup-config copy disk0 system-manifest FI09010f_Manifest.txt primary switch reload enable conf t ip address xxx.xxx.x.x. 255.255.255.0 ip default-gateway xxx.xxx.x.x web-management http write mem exit reload...

Got it

i even went from 8095k and upgraded to the 8095m worked like a charm but for some reason why time it touchs 9.0 software its goes in to bipolar mode

Well, that didnt work at all It installed and I can see it on putty but it wont fully boot i get alot of random debug errors for some reason i tryed to up date with the copy tftp flash and the manifest text both work i can see it on sh ver but will not load.