hmw's latest activity
-
HI also have a support request in with tyan, I'll report back how it goes. I'm expecting a better answer than the equivalent "We do not...
-
Hhmw replied to the thread Tyan S8030GM2NE.I checked the ESXi hardware compatibility - here's the S80XX series for Tyan Model CPU Series Supported Releases S8026 AMD EPYC...
-
Hhmw replied to the thread Tyan S8030GM2NE.I raised a support ticket with Tyan about the BIOS v3.01 issue and they said 'We do not support ESXi 7.0 unfortunately' :eek: Well I...
-
Hhmw replied to the thread Tyan S8030GM2NE.Zen 3 is supposed to have much lower idle power + faster floating point. I might actually go for a 24 core CPU to replace the current...
-
Hhmw replied to the thread Tyan S8030GM2NE.Jordan - did you have to RMA the board? The bent pin couldn't be straightened out back? I'm a bit worried about the ESXi 7.0...
-
Hhmw replied to the thread Tyan S8030GM2NE.I have to report - BIOS v3.01 caused some weirdness with my motherboard. The server runs ESXi 7.0b and has - NIC0 disconnected - NIC1...
-
Hhmw replied to the thread Epyc Rome 7002 series, performance impact.Depends entirely on the application. What are you planning to run on there ?
-
Hhmw replied to the thread Tyan S8030GM2NE.I noticed a new version of the BIOS on Tyan's web page - ver 3.01 Here's the change log. Will try to install it over the weekend ...
-
Hhmw replied to the thread Epyc 7302P & H11SSL-NC Workstation Build: Follow-Up Report.These are server class CPUs and like the modern Xeons, they need to be tightened with the *exact* amount of torque. I would advise you...
-
Hhmw replied to the thread GBASE-T transceivers performance with NBASE-T - Marvell 88x3300 v/s Aquantia AQS-107.That may or may not have the AQ-107 chip. Anecdotal evidence suggests the earlier OPTCore versions did have the Aquantia chip but later...
-
Hhmw replied to the thread Brocade ICX Series (cheap & powerful 10gbE/40gbE switching).very true !
-
Hhmw reacted to fohdeesha's post in the thread Brocade ICX Series (cheap & powerful 10gbE/40gbE switching) with
Like.
I've been holding off on updating the guide to use 8030u as initially the brocade subreddit and the ICX usergroup on Ruckus's support... -
Hhmw replied to the thread [ESX7] Change SCSI Controller virtual PFSense LSI SAS => pvSCSI.If your underlying storage is an SSD and if your guest OS supports it - why not use the NVMe driver? If the underlying storage is NVMe...
-
Hhmw replied to the thread Switches that support 10Gb over cat. 5e cables.Don't you need a Gateway license or similar for the SX6036? Isn't this an Infiniband switch?
-
Hhmw replied to the thread Switches that support 10Gb over cat. 5e cables.The runs are 30 ft and 100ft When using Aquantia SFP modules I can do 10G bi-directionally and 2.5G/5G as well When using Marvell...