Update:
In my case, EMC-OEM sx6012 units, I was able to get the fru_backplate.bin backup command to succeed by changing the bus from '8' to '1' .
Perhaps of help if anyone else is having challenges with this step.
I'm now at v3.4.0012 (upgraded using HPE images starting with "manufacture.sh"...
I seem to be having the opposite problem, in that I can read the cpu fru but not the backplate fru per output below.
Anyone have any suggestions? I was hoping to avoid the need to connect a raspberry pi to the i2c to re-write the fru data, but that may be my next step unless there is any...
Had this same problem with a SN2100. Should it still be of any help, I can confirm that you *can* use a non specific mSATA M.2 device and it will work fine. Does NOT need to be a specific Mellanox rebranded InnoDisk device. HTH
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.