Recently grabbed an EPYC Genoa 100-000000894-04 engineering sample. I haven't been able to boot it - curious if anyone else has tried this before and the results they got.
Motherboard: Supermicro H13SSL-NT
Cooler: Dynatron J12
PSU: Brand new EVGA 750 GT (ATX v2.52)
Motherboard BIOS is version 1.2
With the CPU installed and no heatsink, the BMC heartbeat shows up as expected and I can access the management port with no issue.
However--when the heatsink is installed and tightened, no LEDS show when given power and the board acts completely dead.
Seems like I might be in the same boat as this thread regarding SP3, since also don't have the system power LED on at any point.
When using a 24-pin jumper the CPU fan does come on.
I'm not sure what to suspect right now, as far as I can tell this configuration should be supported, maybe the board is faulty?
Motherboard: Supermicro H13SSL-NT
Cooler: Dynatron J12
PSU: Brand new EVGA 750 GT (ATX v2.52)
Motherboard BIOS is version 1.2
With the CPU installed and no heatsink, the BMC heartbeat shows up as expected and I can access the management port with no issue.
However--when the heatsink is installed and tightened, no LEDS show when given power and the board acts completely dead.
Seems like I might be in the same boat as this thread regarding SP3, since also don't have the system power LED on at any point.
When using a 24-pin jumper the CPU fan does come on.
I'm not sure what to suspect right now, as far as I can tell this configuration should be supported, maybe the board is faulty?
Last edited: