Can you do
show interface 1/1/1
Then
Show mac-address eth 1/1/1
Then
Show arp int eth 1/1/1
Then
show 802.1w
On your PC open a command prompt and do
Arp -a
If you setup another port untagged in vlan 10 can, and you give another device and IP, can your PC and that device see each other? Ping and Do arp -a again to confirm
Is your PC connected to another network? Is there an IP address space overlap on the other network?
Have you tried a differant cable?
This is probably not your problem, but Why do you have spanning tree running on the L3 link? Why is it a /24?
show interface 1/1/1
Then
Show mac-address eth 1/1/1
Then
Show arp int eth 1/1/1
Then
show 802.1w
On your PC open a command prompt and do
Arp -a
If you setup another port untagged in vlan 10 can, and you give another device and IP, can your PC and that device see each other? Ping and Do arp -a again to confirm
Is your PC connected to another network? Is there an IP address space overlap on the other network?
Have you tried a differant cable?
This is probably not your problem, but Why do you have spanning tree running on the L3 link? Why is it a /24?
Last edited: