Hello,
I just rent a new server and installed everything through KVM.
It is my first time to use Adaptec RAID controller, and while checking the settings I noticed the consistency check is disabled by default. I remember with LSi, this option was always enabled by default.
Should I enable it on the Adaptec controller too?
it is Raid 10 configuration with SSD's using ASR8405 if it matters.
Thank you
I just rent a new server and installed everything through KVM.
It is my first time to use Adaptec RAID controller, and while checking the settings I noticed the consistency check is disabled by default. I remember with LSi, this option was always enabled by default.
Should I enable it on the Adaptec controller too?
it is Raid 10 configuration with SSD's using ASR8405 if it matters.
Thank you