Hi.
I recently purchased a Supermicro X10SLM-LN4F and an E3-1220v3 CPU (different sellers).
When plugged in and with validated Kingston ram sticks the board powers on but no video, no USB power (ie. no keyboard lights), no beep codes.
Taking out the ram results in no change (ie. no ram issue beep codes).
The CPU pads and CPU socket both look good. The VGA enable jumper is set. Popping the CMOS battery for a while and then putting it in again result in no change. The IPMI network port seems to connect and the lights blink with data transmission but IPMIView cannot find the IP address on my lan so I suspect it is a fixed IP or not working as expected.
Both vendors have fairly decent feedback scores and one (CPU) I have bought from a number of times with no issues. I have sent a message to the MB vendor.
Anyone else seen this behaviour and any other suggestions on things I could try ?.
I recently purchased a Supermicro X10SLM-LN4F and an E3-1220v3 CPU (different sellers).
When plugged in and with validated Kingston ram sticks the board powers on but no video, no USB power (ie. no keyboard lights), no beep codes.
Taking out the ram results in no change (ie. no ram issue beep codes).
The CPU pads and CPU socket both look good. The VGA enable jumper is set. Popping the CMOS battery for a while and then putting it in again result in no change. The IPMI network port seems to connect and the lights blink with data transmission but IPMIView cannot find the IP address on my lan so I suspect it is a fixed IP or not working as expected.
Both vendors have fairly decent feedback scores and one (CPU) I have bought from a number of times with no issues. I have sent a message to the MB vendor.
Anyone else seen this behaviour and any other suggestions on things I could try ?.