So after a couple of print tests I finally have a version which I'm happy with the results:
* I just noticed the screw laying around the CPU cooler lol.
Main changes:
- Holes are slightly wider as I'm securing the bracket with the included head-screws that came with the Noctua SecureFirm kit as shown in the picture.
- Hole positions have been accommodated to match the socket size of the EPYC 3K board.
- The position of the CPU Cooler has been moved to no interfere with the PCIe slot for when a card is in place as you can see in the picture.
- Because of the change of position I had to cut the height in the backside of the bracket as was interfering with the heat pipes.
So the only task left is to print it on PC, so from the companies, I found locally none of them responded, so I'm going to order the print via T
reatstock which I'm not sure how long is going to take, but well I will wait
Again thank you very much for the help.
Regards.
Rolando