So I bought one @$250 before they were relisted. Made a copper shim 30mm x 30 mm x 0.05mm, slapped on some thermal paste, and installed a SNK-C0057A4L. Cleared the BIOS and booted it up. So far, so good with a single DIMM though not exhaustive by any stretch. The heatsink is warm to the touch while I was poking around the BIOS/IPMI. None of the sensors were reading in IPMI after I did the factory reset.
The BIOS "splash screen" is a Microsoft logo so that probably explains where they came from.
I didn't mess with it as much as I wanted too but will get back to it tonight. The BIOS rev was 1.1c, didn't catch the IPMI version. Hoping I get sensor data back after updating/refreshing both.
I’m glad you got a promising one! The board I got is damaged. Something is wrong with the power distribution on the board. Shorting the power-on contacts does nothing. Shorting the PSU power-on pins powers up the fans, but not the core.
I used the same approach - A copper shim between the heatsink and die. For those also getting boards; be sure to watch the caps on the package. The back side of the flip chips are lower making it very easy to damage the capacitors. Replacing those is no fun!
Did you give it a shot with only the 4-pin 12v connected? Mine automatically powers on after I cleared the CMOS with the 24-pin connected. Don't know if you tried swapping between the two yet, but might be worth a shot.
Wild...I can't remember what my IPMI was configured to, but it was static and I reconfigured my workstation with an IP in the same network initially. I can double check in the AM, you'll likely need to ping sweep the entire range if it is configured like mine was.Thanks for the advice! Unfortunately - No luck with either the a 24-pin ATX or 4-pin 12V supply. The BMC LED lights up and beats, but shorting either the clear CMOS or power-on jumpers does nothing. Shorting the power-on pin on the supply powers on some parts of the board (fans spin, power LED turns green), but the board does not POST.
Yes - That was the first thing I checked. I've wasted hours troubleshooting a board with a dead CMOS battery before =)Wild...I can't remember what my IPMI was configured to, but it was static and I reconfigured my workstation with an IP in the same network initially. I can double check in the AM, you'll likely need to ping sweep the entire range if it is configured like mine was.
What are you using for memory?
Speaking from experience—have you checked if the CMOS battery is dead?
The IPMI address on mine was 10.128.52.212/22 and the Supermicro default credentials worked. No VLAN tagged, but the IPMI interface was set to Shared/Failover I believe. The IO shield had a "POD16 perf" label on it.That will be much appreciated! I'm working to get into the BMC now. As for the memory - I tried both Hynix and Samsung 8 GB RDIMMs. Both DIMMs worked in an X10SDV-8C previously, so I believe this are compatible.
Yes - That was the first thing I checked. I've wasted hours troubleshooting a board with a dead CMOS battery before =)
The IPMI address on mine was 10.128.52.212/22 and the Supermicro default credentials worked. No VLAN tagged, but the IPMI interface was set to Shared/Failover I believe. The IO shield had a "POD16 perf" label on it.