My e300-8d was the new setup device. I want to establish 10G link with its onboard SFP+ interface to my Cisco WS-C3560CX-12PD-S switch.
Both side of the 10G link, I am using Cisco SFP+ 850nm MM.
The e300-8d shows the laser good.
But when the ESXi has been boot up, the link still in "down" status. I swapped the fiber and the SFP+ module, it still the same.
The NIC driver has been upgraded to the newest for "ixgbe".
Is there one who has any idea about this issue?
Thanks
Sunny
Both side of the 10G link, I am using Cisco SFP+ 850nm MM.
The e300-8d shows the laser good.
But when the ESXi has been boot up, the link still in "down" status. I swapped the fiber and the SFP+ module, it still the same.
The NIC driver has been upgraded to the newest for "ixgbe".
Is there one who has any idea about this issue?
Thanks
Sunny