Supermicro CSE-846BE1C-R1K03JBOD Chassis

[Jacoub2490]

Greetings all
I know this is a JBOD Chassis. But is it possible to install an EATX 13x13 MB or ATX MB?
Does it have enough CPU 8 PIN Power connectors?
Are the MB mounting holes aligned with the Case?
Can you suggest a 120mm Fan wall replacement?
The Control Panel Connecter is it compatible with Supermicro Motherboards?

Thanks in advance

 

[frankharv]

The standoff appear to be correct for ATX or EATX.
Not sure about the 8 Pin power. I don't see them.
For Dual CPU board you would need two. They might be wire-tied in the bundle and not visible in pix I see.

Is the front panel cable correct? That is a good question. SuperMicro is consistent with FP so I would bet its OK.

The Aspeed BMC module looks modular with four screws. Back Window looks correct as do slots.

I assume its 1K power modules so don't go crazy with other load. 36 drives would need some kick at bootup..

 

[frankharv]

Based on the pictures here you can probably reuse the drive cabling.

Supermicro CSE-846BE1C-R1K03JBOD Chassis - Rack-mountable - 4U - SAS backplane | eBay

SEE ALL PHOTOS.

www.ebay.com

Four SFF-8643 from the backplanes.

Can you suggest a 120mm Fan wall replacement?

Why this is a standard server setup.... I assume you are talking about the 3 fans mid-chassis?

Depending on cooling solution you might want to look into an air shroud for CSE-846.
These direct air from the two fans above IO shield window from the CPU's.