SPC741D8UD-2T/X550 memory issues

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

sash

Member
Nov 22, 2019
47
11
8
Hello.
I have acquired SPC741D8UD-2T/X550 motherboard. Paired it with Xeon Gold 6416H and put 8 sticks of 64GB MTC40F2046S1RC48BA1 memory. That should have given me 512GB of total memory. Memory was bought from the QVL list specifically. System was put into supermicro 826BE16-R920LPB case. However, when I powered the system on, it could only see 6 out of 8 sticks. Sometimes it saw 2 out of 8 sticks. It varied from one reboot to another. Windows shows even less actual memory than 6 sticks. What settings am I missing in the bios to have all 8 memory modules working in a quad channel config? Thank you for any suggestions...
Attaching some screen shots.
Screenshot 2023-07-27 at 17.47.34.jpg Screenshot 2023-07-27 at 19.43.21.jpg image.png boot.jpg bios01.jpg bios02.jpg
 
Last edited:
"the following channel did not pass CPU memory test. Please remove the memory and plug again "
remove CPU, clean contacts. seat CPU again, turn all 4 screws crosswise to the end, the first time a torque-screwdriver may help.
if not help, set memory frq. manualy to 4400Mt to check BIOS issue.
 
I am not sure if this is the cause, but I did have all 4 PCIe x16 slots populated with devices and used x4 nvme ssd in the available motherboard slot. Three of the x16 slots were taken by x16 devices and one by 8x device. My devices alone ate 16*3+8+4=60 PCIe lanes. System has 97 lanes if I count all of them from the manual. I removed 100Gb nic that freed full x16 slot, installed every dim one by one in A1 slot and tested booting. After that installed all 8 dims and they all were recognized this time.

20230803_202653.jpg Screenshot 2023-08-04 at 19.03.36.jpg
 
Hello.
I have acquired SPC741D8UD-2T/X550 motherboard. Paired it with Xeon Gold 6416H and put 8 sticks of 64GB MTC40F2046S1RC48BA1 memory. That should have given me 512GB of total memory. Memory was bought from the QVL list specifically. System was put into supermicro 826BE16-R920LPB case. However, when I powered the system on, it could only see 6 out of 8 sticks. Sometimes it saw 2 out of 8 sticks. It varied from one reboot to another. Windows shows even less actual memory than 6 sticks. What settings am I missing in the bios to have all 8 memory modules working in a quad channel config? Thank you for any suggestions...
Attaching some screen shots.
View attachment 30622 View attachment 30634 View attachment 30623 View attachment 30624 View attachment 30626 View attachment 30627
I am hoping you receive a notification about this message.

You got this before the bios update of September 2023. Do you happen to have any old BIOS files for this prior to release 10.06 hanging out in your downloads folder?

I would be eternally grateful to get a copy