Hello out there, I hope to get further hints how to get my D2607 flashed to the latest IR firmware.
The adapter was found on Ebay Germany for ~40EUR.
I have been through a lot of reading, tried to follow the suggestions and the various tool and FW/ROM versions, but whatever I try, I get an error. Mostly its "Failed to validate Mfg page 2", sometimes followed by "FW returned exception, IOCStatus 0 =x4 or 0x20 or 0x25, IOCLogInfo = 0x0".
Tried all availabe DOS versions including the LSI rescue ISO, and all efi version from P15 onward. Mainboards are ASUS M5A99X EVO R2 for efi (DOS does not work due to PAL error), tried also to use an ASUS M3N-WS with pure DOS.
Reading the SAS-address with megarec worked fine, also deleting the flash.
Tried all SBR versions I could find. sas2hax.efi gives the same Mfg page 2 error as the other efi tools.
Baseline: Fujitsu 9211-8i D2607 LSISAS2008 wont flash to anything
Thanks for your feedback, Owl
The adapter was found on Ebay Germany for ~40EUR.
I have been through a lot of reading, tried to follow the suggestions and the various tool and FW/ROM versions, but whatever I try, I get an error. Mostly its "Failed to validate Mfg page 2", sometimes followed by "FW returned exception, IOCStatus 0 =x4 or 0x20 or 0x25, IOCLogInfo = 0x0".
Tried all availabe DOS versions including the LSI rescue ISO, and all efi version from P15 onward. Mainboards are ASUS M5A99X EVO R2 for efi (DOS does not work due to PAL error), tried also to use an ASUS M3N-WS with pure DOS.
Reading the SAS-address with megarec worked fine, also deleting the flash.
Tried all SBR versions I could find. sas2hax.efi gives the same Mfg page 2 error as the other efi tools.
Baseline: Fujitsu 9211-8i D2607 LSISAS2008 wont flash to anything
Thanks for your feedback, Owl