SFP+ PCIe NIC that supports bidirectional transceivers?

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

troupbargain

New Member
Dec 9, 2024
6
3
3
I have these transceivers from FS.com and I want to use them in an ICX 6610. However, they're not detected. Apparently earlier Brocade switches didn't support BiDi modules. So I wanted to modify the EEPROM to show up as a duplex transceiver. I have a Banana Pi R4 board with SFP+ cages. However, I'm unable to edit the EEPROM with the MTK driver:
Code:
root@OpenWrt:~# ethtool --driver eth2
driver: mtk_soc_eth
version: 6.6.63
firmware-version:
expansion-rom-version:
bus-info: 15100000.ethernet
supports-statistics: yes
supports-test: no
supports-eeprom-access: no
supports-register-dump: no
supports-priv-flags: no
So, I got an Intel X520 PCIe card to use in my desktop PC. However, the interface fails to come up, even with the allow_unsupported_sfp=1 kernel parameter set.
Code:
[  554.368379] ixgbe: Intel(R) 10 Gigabit PCI Express Network Driver
[  554.368382] ixgbe: Copyright (c) 1999-2016 Intel Corporation.
[  554.386741] ixgbe 0000:02:00.0: failed to load because an unsupported SFP+ or QSFP module type was detected.
[  554.386747] ixgbe 0000:02:00.0: Reload the driver after installing a supported module.
[  554.386791] ixgbe: probe of 0000:02:00.0 failed with error -95

Does anyone have any suggestions?