This is how I did it. https://forums.servethehome.com/ind...rocade-icx-6450-ruckus-r720.26547/post-254295I wish to setup up LACP on a R610 AP to my ICX6450 48POE. I
Would someone be willing to guide me along,step by step? Does the 2nd port also need POE?
much thanks
although the latest unleashed software cli guide states you can ssh into each AP and issue the command:
Code:
ruckus> en
ruckus# ap-mode
You have all rights in this mode.
ruckus(config-ap)# status-lacp enable
ruckus(ap-mode)# get bond
LACP/Bonding is ENABLED.
<bond0>
544
RUCKUS Unleashed 200.10 Command Line Interface Reference Guide Part Number: 800-72824-001 Rev A
Mode: 8023AD
LACP-rate: fast
MII-Mon: 100 (ms)
Xmit-Hash: layer2+3
Slaves: 2
Slave-0: eth0, ACTIVE, DOWN TOO LONG, link-fail-count: 0
Slave-1: eth1, ACTIVE, UP, link-fail-count: 0
OK