Pulsar SSD Drives Not Ready

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

Seion

Member
Sep 1, 2016
37
19
8
40
Northern Kentucky
I have 4 of the following drives:
  • Brand: Seagate
  • Model: ST400FX0002, which is the Pulsar XT.2 line
  • Type: 400 GB SLC enterprise SSD, 2.5-inch, SAS 6 Gb/s

I had 2 of them in a zpool stripe and they were working fine and I noticed the writes were a little slow so I threw a zpool trim command at it and it has seem to broke 1 of th drives. The HP03 firmware one seems to work fine and has full write speed back after a low level format. But the other ones ( I borked 2 with the same trim command ) always report 0 bytes and not ready. I pulled both of them in a full power off for more than 60 seconds and I cannot get them to come back. They seem to be on firmware HP02.

```
# [ "$(cat /sys/class/scsi_generic/sg0/device/model | xargs)" = EO0400BAHZQ ] && sg_raw -v -t 7200 /dev/sg0 04 00 00 00 00 00
cdb to send: [04 00 00 00 00 00]
SCSI Status: Check Condition

Sense Information:
Fixed format, current; Sense key: Not Ready
ASC=04, vendor specific qualification ASCQ=f2 (hex)
Raw sense data (in hex), sb_len=18, calculated_len=18
70 00 02 00 00 00 00 0a 00 00 00 00 04 f2 00 00
00 00


Device not ready
```

```
# [ "$(cat /sys/class/scsi_generic/sg0/device/model | xargs)" = EO0400BAHZQ ] && sg_format --format /dev/sg0
HP EO0400BAHZQ HP02 peripheral_type: disk [0x0]
MODE SENSE (10) command: Device not ready
try '-v' for more information
sg_format failed: Device not ready
```

```
# for w in 5000c500001aba03 5000c500001ab9fb; do sdparm --get=WCE /dev/disk/by-id/wwn-0x$w; done
/dev/disk/by-id/wwn-0x5000c500001aba03: HP EO0400FCDXB HP03
WCE 1 [cha: y, def: 1, sav: 1]
/dev/disk/by-id/wwn-0x5000c500001ab9fb: HP EO0400BAHZQ HP02
WCE 1 [cha: y, def: 1, sav: 1]
```

Any ideas on how to recover them, I tried throwing the format command at them also, still not ready errors.