Problems Flashing Dell Perc H310

[Stumpy]

Hi

I bought an Dell Perc H310 SATA / SAS HBA Controller RAID 6Gbps PCIe x8 LSI 9240-8i M1015 from Ebay and tried to Flash the Firmware to IT.

I followed several guides, but none were succesfull, the IR Firmware is still there -.-

1st try

2nd try (needed Uefi) Updated: SAS HBA crossflashing or flashing to IT mode, Dell Perc H200 and H310
3rd and last try LSI Controller FW updates IR/IT modes

from the last post i used the *.nsh scripts, so i cant do anythin wrong.
these scripts made the same i did before and did log everything.
I uploaded the logs.

The script reads the Data from the card and writes it to the usb stick for later use.
After that it deletes the Flash Region, marked as Successfull
Then i install the Dell Firmware and this is marked as successfull too.

The next step is the failing one it seems.
Flashing the 2118itP7 firmware fails due to "Firmware Image Validation Failed"

What can i do to fix this?

Greetings
Stumpy

 

[Stumpy]

i finally made it.
had to usee an old consumer board and used the 3rd version (via batches in freedos).
thread can be closed.

 

[Spartacus]

Just fyi for the H310s I think you're supposed to use the 6GBPSAS.fw to avoid that, not the 2118itP7 (the P7.bin is for the M1015).
Though as you found they both work, each card variation just preferred flash methods.

This is the guide I've used for several H310 flashes (I prefer to have the bios on it): Flash Dell PERC H310 to LSI 9211-8i IT Mode Using Legacy (DOS) and UEFI Method (HBA Firmware + BIOS) | JC-LAN.org