Hi guys,
Recently I'm trying to design an isolation PCB board that can connect ATX power from one side of the board to the other side of the board. However, I have no idea which connector should be used on the board for the following connectors:
- 8-pin EPS +12V connector
- 4-pin CPU power connector
- 6/8 pin PCIe power connector.
Is there anyone that's familiar with either MOLEX products or similar products and can give me some advice?
Also, if anyone knows what copper thickness (2oz?) I should use on this board, that would be much appreciated.
Thanks!
Recently I'm trying to design an isolation PCB board that can connect ATX power from one side of the board to the other side of the board. However, I have no idea which connector should be used on the board for the following connectors:
- 8-pin EPS +12V connector
- 4-pin CPU power connector
- 6/8 pin PCIe power connector.
Is there anyone that's familiar with either MOLEX products or similar products and can give me some advice?
Also, if anyone knows what copper thickness (2oz?) I should use on this board, that would be much appreciated.
Thanks!