Yes this is known. Onyx has already been in LTS mode sind some time without major updates.I can confirm that Onyx will be discontinued in the near future (MLNX-OS is not affected, but the eth product will not be supported)
Later support for eth products will be Cumulus Linux and SONiC, or...switchdev
Nobody who needs such a switch should use a WebUI anyway... (Ignoring Netbox with declarative management that automatically deploys to switches - but that's still not a UI for the switch)Cumulus Linux and SONiC and even switchdev have lost out-of-the-box webui support for users.
1. looks like normal Mellanox, not Dell OEMCan someone confirm or deny following regarding Mellanox SX6012:![]()
1. This should be original Mellanox, correct (black/blue faceplate)?
2. Can this switch be converted from InfiniBand to Ethernet mode ? If yes, how ?
3. Does this switch has web GUI for configuration ? I'm bad at CLI and need only basic stuff.
Thanks in advance !
license install LK2-EFM_SX-5L11-5M11-5K11-5T11-5U11-5G22-05J2-205N-2205-P220-88A2-L5T5-3MYW-9
Yes it will work. However single stream throughput will be limited to 10Gbit/s due to the way link aggregation works. Total throughout can reach 40Gbit/s but only if you have multiple streams (different source/dest mac or ip or port)Another question regarding Mellanox SX6012:
- I'm planing to connect this switch and Mikrotik CCR2116-12G-4S+ with QSFP+ to 4xSFP+ breakout cable (Mikrotik has 4 x SFP+ port) and to do interface bonding, to get 40Gbit between those two devices. In theory it should work. Anyone have any experience in similar matter ?
Thanks
What is the old version?I did run into a problem with one of them when trying to upgrade and don't know what to do.
I can boot the old software and log in, after the new installation it gives trouble, see logs below.
Anyone has some advice?
Hm that‘s weird. Can you try letting the 3.9 fully boot and send the output of show asic-version?Version summary: X86_64 3.9.2006 2020-12-02 16:59:03 x86_64
Interesting - what can Onyx do what Cumulus can‘t?Interesting, for this project we need ONYX though
Try to update the 3.9 partition to 3.9.3124, that might work.Does this tell you something?
I‘ll see what I can do once I‘m back home in an hour or soAha, I only have 3.9.3202...
Would it be possible to help me with 3.9.3124?
Thanks for the help so far
Interesting, can you share a Cumulus image so we can test it as well ?What is the old version?
Fun fact: I‘m migrating everything from Onyx to Cumulus. Cumulus rocks
Worked out by using 3.9.3202, thanks for the help.I‘ll see what I can do once I‘m back home in an hour or so