I just finished my JBOD:
There is however one cable I don't understand.
It was connected to the chassis when I got it and has two pins/cables (red black).
I _assume_ this is grounding. But why two cables? Also, I do not see where to attach it to the CB3.
The CB3 manual does not mention grounding.
The Control Panel Connector: JF1 (Number 8 in the manual) has two free pins (the outer left ones) - is this perhaps the grounding?
[Edit]
I think I was looking at the manual the wrong direction. It seems
Perhaps Pin 20/19 are on the left side. NMI (Non-Maskable-Interrupt) should be the red cable and Ground should be black - correct? See answer below
- Chassis: SC743T-500B
- Board: CSE-PTJBOD-CB3
- Backplane: CSE-SAS-743TQ
There is however one cable I don't understand.
It was connected to the chassis when I got it and has two pins/cables (red black).
I _assume_ this is grounding. But why two cables? Also, I do not see where to attach it to the CB3.
The CB3 manual does not mention grounding.
The Control Panel Connector: JF1 (Number 8 in the manual) has two free pins (the outer left ones) - is this perhaps the grounding?
[Edit]
I think I was looking at the manual the wrong direction. It seems
Last edited: