Pretty cheap dual LGA2011-3 boards on ebay right now if you don't mind introducing your chassis with angle grinder due to OCP slot (assuming it'll be used). There's no onboard nic and that single ethernet connector is for IPMI/BMC. SAS connectors seem to be for SATA connectivity.
Received mine on last friday. It's bit wider than normal EATX board but at quick glance it should fit into supermicro EEATX chassis. Power connectors are plain normal 24pin ATX and 8-pin EPS.
Currently most of these boards are sold on ebay as 2011-0/DDR3 boards so don't do the same mistake as I made. Not that I really mind as I've CPUs and use for it eventually.
My SC213 test bench on my couch. Pair of E5-2690v3's and 2x32GB loaner ram installed for quick test. I don't own any DDR4 at the moment and was only able loan some ram for this evening. So I can't do really extensive testing, just wanted to make sure the board works.
Fan spin and blinking debug lights is always a good sign.
Boots into bios/uefi without any boot media/nics installed.
Didn't even mind about the ES chips. Haven't tested if v4 cpus work (yet). Next step for this board is to get fabricobbled into SC213 chassis.
Received mine on last friday. It's bit wider than normal EATX board but at quick glance it should fit into supermicro EEATX chassis. Power connectors are plain normal 24pin ATX and 8-pin EPS.
Currently most of these boards are sold on ebay as 2011-0/DDR3 boards so don't do the same mistake as I made. Not that I really mind as I've CPUs and use for it eventually.
My SC213 test bench on my couch. Pair of E5-2690v3's and 2x32GB loaner ram installed for quick test. I don't own any DDR4 at the moment and was only able loan some ram for this evening. So I can't do really extensive testing, just wanted to make sure the board works.
Fan spin and blinking debug lights is always a good sign.
Boots into bios/uefi without any boot media/nics installed.
Didn't even mind about the ES chips. Haven't tested if v4 cpus work (yet). Next step for this board is to get fabricobbled into SC213 chassis.