"orange light at plug" unknown to me.
orange flashing light at PSU indicates a problem with the PSU.
I MIGHT HAVE UNDERESTIMATED....
- Thread starter oddssodds
- Start date
Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.
orange flashing light at PSU indicates a problem with the PSU.
Well the power supply is stuck in "short" with the orange light. If i pull it from the chassis, it is fine. Using good coolant with uv. Liquid went everywhere. I think the board is done. Log shows tons of shorts in the memory during the water works.
Well maybe the fourth board will make it...
Well maybe the fourth board will make it...
So, the last few days have been hell. I pulled the board and it was dead. I went and got a replacement board and set up to run the pump off of another computer with the board off. Started the machine and got an error on cpu 2. Pulled the heat sink away from the socket and there was something on the die. I blew it out and the tip of the air nozzle bashed the pins in socket2.
Another board.
This time I was taking no chances. Powered the pump remotely and covered all the internals in case of a leak
This time no leak. Cpu's triple checked. Ran the cooling system for hours and let it sit overnight.
Powered the machine up this morning and got this
Realized I had installed the board without updating the vrm. So I started it to idrac and updated the vrm, which worked.
restarted with a cleared log and got
What now? CLPD is already 1.14. Idrac is 5.00.20.10 . Bios is 2.13
@RolloZ170
Another board.
This time I was taking no chances. Powered the pump remotely and covered all the internals in case of a leak
This time no leak. Cpu's triple checked. Ran the cooling system for hours and let it sit overnight.
Powered the machine up this morning and got this
Realized I had installed the board without updating the vrm. So I started it to idrac and updated the vrm, which worked.
restarted with a cleared log and got
What now? CLPD is already 1.14. Idrac is 5.00.20.10 . Bios is 2.13
@RolloZ170
this is what i got without front VGA cable, without Left/Right ears, without Chassis Intrusion switch.
storage BP1 signal cable is not connected is what it means.
Pfault fail-safe voltage is outside of range and CPU2 VCCIO PG voltage is otside of range are things you had too with the first board ?
improper cpu installations.
The first errors are pretty clear and don't stop the machine from starting
the voltage pfault was what I was getting on the first board, but I had swapped the processors and still had the same error. The assumption was that the socket was dead
going to try and strip down the ram on 2 to one stick and see what happens
started it twice with jumper moved, one stick of ram in processor two. processor 2 warning gone. just pfault
PFault can be related to processor too.
seach for that error, you find 100s of results.
Moved the jumper back and removed all ram, except one, from cpu 1
waiting for error log
remove all not required things. have read bad SSD can result in similar errors due to a firmware bug.
new board: PSU reconfigured as single in iDrac ?
mayb PSU lost in leak ?