I'm trying to make this P410 work, but it behaves strangely. I must say I'm not using HP hardware to test it, but rather a Dell motherboard.
When I use the card with the cache module and battery attached, it gives me a failure message and doesn't go any further. The boot does not complete.
After I power it off and then on again, the same thing happens, same message and no boot.
If I detach the cache+battery it seems to initialize for a few seconds, but then reboots, shows the same message again, reboots etc.
powering off and on again just restarts the whole cycle without any change.
If I attach the cache+battery back, it goes back to the first behavior with the failure message.
This is the card, with cache detached
Is there anything I can do at this point to make it work?
When I use the card with the cache module and battery attached, it gives me a failure message and doesn't go any further. The boot does not complete.
After I power it off and then on again, the same thing happens, same message and no boot.
If I detach the cache+battery it seems to initialize for a few seconds, but then reboots, shows the same message again, reboots etc.
powering off and on again just restarts the whole cycle without any change.
If I attach the cache+battery back, it goes back to the first behavior with the failure message.
This is the card, with cache detached
Is there anything I can do at this point to make it work?