smartctl 6.6 2017-11-05 r4594 [x86_64-linux-5.10.0-0.deb10.16-amd64] (local build)
Copyright (C) 2002-17, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Vendor: HITACHI
Product: HUH72808CLAR8000
Revision: M7K0
Compliance: SPC-4
User Capacity: 8,001,563,222,016 bytes [8.00 TB]
Logical block size: 4096 bytes
LU is fully provisioned
Rotation Rate: 7200 rpm
Form Factor: 3.5 inches
Logical Unit id: 0x5000cca254a5829c
Serial number: VKJY0SUX
Device type: disk
Transport protocol: SAS (SPL-3)
Local Time is: Thu Sep 15 15:02:36 2022 PDT
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
Temperature Warning: Disabled or Not Supported
Read Cache is: Enabled
Writeback Cache is: Disabled
=== START OF READ SMART DATA SECTION ===
SMART Health Status: OK
Current Drive Temperature: 34 C
Drive Trip Temperature: 60 C
Manufactured in week 22 of year 2016
Specified cycle count over device lifetime: 50000
Accumulated start-stop cycles: 11
Specified load-unload count over device lifetime: 600000
Accumulated load-unload cycles: 1503
Elements in grown defect list: 0
Vendor (Seagate) cache information
Blocks sent to initiator = 4943189362343936
Error counter log:
Errors Corrected by Total Correction Gigabytes Total
ECC rereads/ errors algorithm processed uncorrected
fast | delayed rewrites corrected invocations [10^9 bytes] errors
read: 0 2 0 2 1267535 134249.420 0
write: 0 1 0 1 2036919 40243.264 0
verify: 0 0 0 0 56002 0.000 0
Non-medium error count: 0
SMART Self-test log
Num Test Status segment LifeTime LBA_first_err [SK ASC ASQ]
Description number (hours)
# 1 Background short Completed - 41003 - [- - -]
# 2 Background short Completed - 39557 - [- - -]
# 3 Background short Completed - 38117 - [- - -]
# 4 Background short Completed - 36677 - [- - -]
# 5 Background short Completed - 35237 - [- - -]
# 6 Background short Completed - 33797 - [- - -]
# 7 Background short Completed - 32357 - [- - -]
# 8 Background short Completed - 30917 - [- - -]
# 9 Background short Completed - 29477 - [- - -]
#10 Background short Completed - 28037 - [- - -]
#11 Background short Completed - 26597 - [- - -]
#12 Background short Completed - 25157 - [- - -]
#13 Background short Completed - 23717 - [- - -]
#14 Background short Completed - 22277 - [- - -]
#15 Background short Completed - 20837 - [- - -]
#16 Background short Completed - 19397 - [- - -]
#17 Background short Completed - 17957 - [- - -]
#18 Background short Completed - 16517 - [- - -]
#19 Background short Completed - 15077 - [- - -]
#20 Background short Completed - 13637 - [- - -]
Long (extended) Self Test duration: 6 seconds [0.1 minutes]
Background scan results log
Status: scan is active
Accumulated power on time, hours:minutes 42369:49 [2542189 minutes]
Number of background scans performed: 482, scan progress: 0.00%
Number of background medium scans performed: 482
Protocol Specific port log page for SAS SSP
relative target port id = 1
generation code = 1
number of phys = 1
phy identifier = 0
attached device type: SAS or SATA device
attached reason: unknown
reason: unknown
negotiated logical link rate: phy enabled; 12 Gbps
attached initiator port: ssp=1 stp=1 smp=1
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x5000cca254a5829d
attached SAS address = 0x50014380354449f0
attached phy identifier = 3
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 0
Phy reset problem = 0
Phy event descriptors:
Invalid word count: 0
Running disparity error count: 0
Loss of dword synchronization count: 0
Phy reset problem count: 0
relative target port id = 2
generation code = 1
number of phys = 1
phy identifier = 1
attached device type: no device attached
attached reason: unknown
reason: power on
negotiated logical link rate: phy enabled; unknown
attached initiator port: ssp=0 stp=0 smp=0
attached target port: ssp=0 stp=0 smp=0
SAS address = 0x5000cca254a5829e
attached SAS address = 0x0
attached phy identifier = 0
Invalid DWORD count = 0
Running disparity error count = 0
Loss of DWORD synchronization = 0
Phy reset problem = 0
Phy event descriptors:
Invalid word count: 0
Running disparity error count: 0
Loss of dword synchronization count: 0
Phy reset problem count: 0