Hi guys,
can anyone help me permanently or temporarily change MAC address with U-Boot on Quanta LY2R?
This does not work:
QNOS still shows original MAC address.
Some other "FASTPATH" firmware (whathever was on this, before I installed QNOS) showed the changed MAC in OS (show version), but not QNOS. QNOS shows MAC as written in flash.
So I guess saveenv somehow does not save MAC address to flash.
can anyone help me permanently or temporarily change MAC address with U-Boot on Quanta LY2R?
This does not work:
Code:
=> setenv ethaddr CENSORED:AA
=> saveenv
Saving Environment to Flash...
Un-Protected 1 sectors
Erasing Flash...
. done
Erased 1 sectors
Writing to Flash... 9....8....7....69....8....7....6....5....4....3....2....1....done
Protected 1 sectors
Code:
(Switch) #show version
Switch: 1
System Description............................. LY2R, Runtime Code 19.12L, Linux 3.8.13-rt9, U-Boot 2010.12 (Feb 10 2015 - 10:01:12) - ONIE 2014.05.03-d
Machine Type................................... LY2R
Machine Model.................................. QUANTA LY2R
Serial Number.................................. CENSORED
Part Number.................................... 1LY2BZZ001A
Burned In MAC Address.......................... CENSORED:DD
Software Version............................... 19.12L
Software Storage............................... Flash
License Key Status............................. Key Not Present
Operating System............................... Linux 3.8.13-rt9
Network Processing Device...................... BCM56846_A1
Additional Packages............................ BGP-4
QOS
Multicast
IPv6
Routing
Data Center
OpEN API
Prototype Open API
Some other "FASTPATH" firmware (whathever was on this, before I installed QNOS) showed the changed MAC in OS (show version), but not QNOS. QNOS shows MAC as written in flash.
So I guess saveenv somehow does not save MAC address to flash.
Last edited: