Hey guys trying to enable passthrough for my M1015 that i flashed to IR mode.
The card works without any issues in Esxi 5.5u2
I can make datastores and use them without any issues however when i enable Passthough i reboot the machine and when it comes back up it just says reboot to enable host again.
Will never fully enable. I did notice that it will not enable the dependent for the pci port.
Im wondering if its because im using an Asus P7P55WS Supercomputer Motherboard with has an Nf200 pci switch built in, but im able to pass other devices thorough without any issues.
Any ideas?
The card works without any issues in Esxi 5.5u2
I can make datastores and use them without any issues however when i enable Passthough i reboot the machine and when it comes back up it just says reboot to enable host again.
Will never fully enable. I did notice that it will not enable the dependent for the pci port.
Im wondering if its because im using an Asus P7P55WS Supercomputer Motherboard with has an Nf200 pci switch built in, but im able to pass other devices thorough without any issues.
Any ideas?