check your PMWhere can I download a modded BIOS that works with QL1M?
check your PMWhere can I download a modded BIOS that works with QL1M?
have you tested the X11DPi-N with a known working CPU before ? if not do that to be sure your board is trustable.The BIOS error is "All channels are disabled due to memory test failures."
sure it works with DDR4. but without the microcode and Intel RefCode support it will not work.Can anyone confirm if Intel Xeon QDCS only works with DDR3?
RDIMM ?cannot get it to POST on Huananzhi X99-8M-F with 16GB DDR4
curious !found 1 listing in a Polish website that state the QDCS only works with DDR3 ( Intel Xeon 2695 v3 QDCS Early ES - tylko DDR3 ! | Starogard Gdański | Kup teraz na Allegro Lokalnie ).
So now I should try my luck by adding microcode to the BIOS right )sure it works with DDR4. but without the microcode and Intel RefCode support it will not work.
if this is single ranked it will NOT work, haswell only 8GB per Rank.Yep only 1 stick of SK Hynix RECC 16GB 2133Mhz
i took a look at the X99-8M-F, and was shocked.So now I should try my luck by adding microcode to the BIOS right )
Thanks for the warning, I am aware of that already but I just wanna try if it works (additional VRM cooling is a must tho). I'm also thinking of getting myself an used X99-AD3 to pair with this power-hungry monster.i took a look at the X99-8M-F, and was shocked.
i have a X99-8M which has 6 phase VRM and a real C612 chipset
the X99-8M-F shippes with only 3 phase VRM and a B85 chipset. take care of your VRM they are not made for 135 watts.
it is not a monster, 3 phase is weak, that is the problem.to pair with this power-hungry monster.
have you tested this BIOS with a known working CPU ?I have tried adding 306F0 microcode to the BIOS, but the system still refused to boot. Fan spinning but no beep at all. The CPU did heat up. Any suggestions?
View attachment 20236View attachment 20237
Yes it works with my 2630LV3 no problem.have you tested this BIOS with a known working CPU ?
i think QDCS is a 306F1 CPUI have tried adding 306F0 microcode to the BIOS, but the system still refused to boot.
If that's the case then the 306F1 microcode already exists in my BIOS. What could possibly be causing the problem here then?i think QDCS is a 306F1 CPU
even if the MC is missing or memory is not supported there must be an error post code.If that's the case then the 306F1 microcode already exists in my BIOS. What could possibly be causing the problem here then?