We just got a new Dell OS10 switch. OS10 is different enough from Cisco and Arista that I don't know what I'm doing wrong.
Here's my ask:
Commands to type in the terminal once "enable" is used to get in to privileged mode to put an OS10 switch into a flat L2 no VLAN switch.
I just want to validate that the ports all work. I've got the management interface up on the switch, but following along on Dell's documentation is nowhere near as easy as Arista who spells this out command by command.
Here's my ask:
Commands to type in the terminal once "enable" is used to get in to privileged mode to put an OS10 switch into a flat L2 no VLAN switch.
I just want to validate that the ports all work. I've got the management interface up on the switch, but following along on Dell's documentation is nowhere near as easy as Arista who spells this out command by command.