Did you follow through the initial config that created a VLAN and gave it an IP Address etc ?In the guide it says "By default, all ports are in VLAN 1" for the ICX 6450 does that include the 4SPF+ ports? I have an "Cable Matters 1000BASE-T Gigabit SFP to RJ45 Copper Ethernet Modular Transceiver" but doesn't work(ve interface 1 IP doesn't ping). Using any of the ethernet ports direct works (Cat 7 Ethernet Cable High-Speed Flat Gigabit RJ45 LAN)
If not how can I add them?
Did you take away the stacking config for the SFP+ ports and then follow the licenscing to ensure they were then enabled as SFP+ standard use ports ?
This is what i have ended up with after following the config and have confirmed that one of the SFP+ ports work when attached to an Intel DAC
SSH@CURTO-6610#show run
Current configuration:
!
ver 08.0.30uT7f3
!
stack unit 1
module 1 icx6610-48-port-management-module
module 2 icx6610-qsfp-10-port-160g-module
module 3 icx6610-8-port-10g-dual-mode-module
stack disable
!
!
!
!
vlan 1 name DEFAULT-VLAN by port
router-interface ve 1
!
!
!
!
!
aaa authentication web-server default local
aaa authentication login default local
enable aaa console
hostname CURTO-6610
ip dhcp-client disable
ip dns server-address 172.16.100.1
ip route 0.0.0.0/0 172.16.100.1
!
no telnet server
username root password .....
!
!
clock summer-time
clock timezone gmt GMT+10
!
!
ntp
disable serve
server 216.239.35.0
server 216.239.35.4
server 172.16.100.1
!
!
no web-management http
!
interface ethernet 1/3/1
speed-duplex 10G-full
!
interface ethernet 1/3/2
speed-duplex 10G-full
!
interface ethernet 1/3/3
speed-duplex 10G-full
!
interface ethernet 1/3/4
speed-duplex 10G-full
!
interface ethernet 1/3/5
speed-duplex 10G-full
!
interface ethernet 1/3/6
speed-duplex 10G-full
!
interface ethernet 1/3/7
speed-duplex 10G-full
!
interface ethernet 1/3/8
speed-duplex 10G-full
!
interface ve 1
ip address 172.16.100.252 255.255.255.0
!
!
end
SSH@CURTO-6610#