Seems my brocade adventure just won't end.
Got a 6610 today. Model number is ICX-6610-24-PE, Version:07.3.02T7f5
Before I did anything else loaded it up. And there is absolutely no signs of this switch supporting PoE. Every other switch mentions initializing PoE on booting.
and
or
At this point I'm not sure if I should start up another RMA or try upgrading the switch. It's got the L2 firmware on it right now, plus it does appear to actually have one license on it, ICX6610-PREM-LIC-SW, which I don't want to risk wiping with a firmware upgrade (in case I have to RMA)
@fohdeesha do these things need the L3 software on them to support PoE?
Edit, and again, think I've been bamboozled. This thing only has a single REVA 250W power supply. Don't they need the 1000W supplies to support POE?
Got a 6610 today. Model number is ICX-6610-24-PE, Version:07.3.02T7f5
Before I did anything else loaded it up. And there is absolutely no signs of this switch supporting PoE. Every other switch mentions initializing PoE on booting.
Code:
ICX6610-24 Switch#show inline power
ICX6610-24 Switch#
Code:
ICX6610-24 Switch(config-if-e1000-1/1/1)#inline power
Command not applicable for non-POE port 1/1/1.
Code:
ICX6610-24 Switch(config-mif-1/1/1-1/1/24)#inline power
set inline power cannot be done on this device with stack id 1 and poe slot 1!
@fohdeesha do these things need the L3 software on them to support PoE?
Edit, and again, think I've been bamboozled. This thing only has a single REVA 250W power supply. Don't they need the 1000W supplies to support POE?
Last edited: