PLEASE NOTE: Socflash will delete the MAC Addresses of the ASMB9 Module.
So MAC Addresses need to be re-write after flashing the Firmware.
Thus, please check in BIOS first for BMC MAC Addresses and note them.
--> BIOS / Server Management
1. Prepare the flash drive:
Unzip attached tool and copy this folder to USB DOS bootable flash drive.
Copy latest ASMB Firmware file *.ima into the folder on the USB stick where you copied the tool before.
2. Set BMC Jumper BMC_EN1 to [Disabled].
3. Boot up the Server
Start the Server and Boot DOS from your previously prepared flash drive.
4. When Server booted into DOS, Set BMC Jumper BMC_EN1 back to [Enabled].
5. Firmware flashing.
Run:
x:\>socflash.exe PAU12151.IMA OLD.IMA
Wait until finish, it will take about 5~10 Minutes
6. Rewrite Mac, finish flashing.
ASMC8.exe -bmc_mac 123456789A10
ASMC8.exe -bmc_mac_lan1 123456789A11
ASMC8.exe -kcs 18 02
If MAC rewrite does not work, shut down the System, unplug power and repeat step 4 again.
After flashing, shut down the Server.
Disconnect power from system for 2 Minutes.
Reconnect power to Server and wait until BMC Heartbeat LED start flashing (Take about three minutes).
Restart Server.