I have always used Supermicro boards, but since my X11SCL-IF is not booting anymore (IPMI is working fine) and buying a new one doesnt seem possible in The Netherlands anymore, i have found an alternative: Asrock C246 WSI
So this is what i will be using:
Xeon E-2224
2 x m378a4g43ab2-cvf (does anymore for sure this will work on my chosen MB?)
Corsair MP510 2TB
SUPERMICRO SSD-DM064-SMCMVN1 - 64GB SATA DOM
The motherboard is like i said the Asrock C246 WSI (The E3C246 also not available here)
I assume this will run ESX 7.0 since it was certified for 6.5.
My question is about the SataDOM.
The MB manual says this:
SATA DOM Power Jumper (3-pin SATAPWR1):
SATA DOM (SATA_4) requires 5V power supply : JUMPER ON 1 & 2
SATA DOM (SATA_4) does NOT require 5V power supply (Default): JUMPER ON 2 & 3
I have never had this Asrock MB and have only used SataDOMs on Supermicro MBs so far.
Do i need to connect the power cable from the DOM to the board and or change the Jumper setting? Or should i use the Default board setting and also not connect the SataDOM power cable?
I don't want to break the mainboard....So i would like to be sure.
So this is what i will be using:
Xeon E-2224
2 x m378a4g43ab2-cvf (does anymore for sure this will work on my chosen MB?)
Corsair MP510 2TB
SUPERMICRO SSD-DM064-SMCMVN1 - 64GB SATA DOM
The motherboard is like i said the Asrock C246 WSI (The E3C246 also not available here)
I assume this will run ESX 7.0 since it was certified for 6.5.
My question is about the SataDOM.
The MB manual says this:
SATA DOM Power Jumper (3-pin SATAPWR1):
SATA DOM (SATA_4) requires 5V power supply : JUMPER ON 1 & 2
SATA DOM (SATA_4) does NOT require 5V power supply (Default): JUMPER ON 2 & 3
I have never had this Asrock MB and have only used SataDOMs on Supermicro MBs so far.
Do i need to connect the power cable from the DOM to the board and or change the Jumper setting? Or should i use the Default board setting and also not connect the SataDOM power cable?
I don't want to break the mainboard....So i would like to be sure.