Anybody know how to set APC vendor specific cookie in windows DHCP?

Notice: Page may contain affiliate links for which we may earn a small commission through services like Amazon Affiliates or Skimlinks.

spyrule

Active Member
So,
I'm trying to setup an APC AP9617 NMC card for my UPS, and its being a pita to get it to DHCP an address.

Turns out I need to set a Vendor Specific Info in my DHCP for it to actually get an address.

The problem, is that I cannot for the life of me, figure out what exactly I need to put in my Windows DHCP Servers binary/text fields to configure this correctly.

As you can imagine, I did the usual ARP -s IP MAC command, and its being picked up on my Network, however its not responding to anything (Telnet, Web nor SSH). So I'm trying to use DHCP instead, but to no avail...