Can anyone tell me what the required LED types are for the 9361-8i connectors J1B1, J6B3, J6B5, J6B7 ?
Update, I messaged broadcom support and got an answer ; however I am still seeking some clarification on one point the response from them was.
"The header current is limited to 25 mA at 3.3V.
Keep in mind, however, that it was designed to drive an LED with a forward voltage drop which is typically around 2V, therefore pulling approximately 10 mA"
Now I am assuming that he it referring to the single board headers but there is one board header with from memory 16 pins which seems to be 2 pins for each LED and I have asked for a determination on if the value in this specific instance is for all 8 LEDs attached to that connector - or if it is a total for the port i.e 25mA/8 leds = 3.1mA per led or if it is 10mA per led.
More info as it comes to hand.
Update, I messaged broadcom support and got an answer ; however I am still seeking some clarification on one point the response from them was.
"The header current is limited to 25 mA at 3.3V.
Keep in mind, however, that it was designed to drive an LED with a forward voltage drop which is typically around 2V, therefore pulling approximately 10 mA"
Now I am assuming that he it referring to the single board headers but there is one board header with from memory 16 pins which seems to be 2 pins for each LED and I have asked for a determination on if the value in this specific instance is for all 8 LEDs attached to that connector - or if it is a total for the port i.e 25mA/8 leds = 3.1mA per led or if it is 10mA per led.
More info as it comes to hand.
Last edited: