Primary air does not go out the top. 2 posts so far mention this, but that's not the case, and you can tell by the fan blades.
Point me towards a Active Heatsink for LGA3647.... Pls show me one.
As is in the picture, the temps get too high, I needed to put a fan atop each cooler to keep the temps in check.. Seeing peak of 93C under heavy continuous load. Under normal load, 5C above ambient
I'll give it a try!
Results: With all the fans on in the case (2x 140mm on top, 3x 1200mm on front, 1x exhausting 140mm at the back), and 120mm fan each atop the passive cooler, the temps jumped from ambient 34C to 72C and steadily rose 1C every couple seconds to slowly stabilize at 93C.
The...
Going through a DP Purley build since last night and with 165W TDP, cooling's going to be a challenge (whether UP or DP) with this LGA3647..
I can't find any 3rd party heatsink vendors yet either
http://i.imgur.com/U8RE8Ss.png
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.