You can use the 2 OPT_12V close by the PCIE_RISER, you just need a 4 Pin Molex To P4/64 Bit ATX 12v
Anything like this will get you a molex, and then you can use a splitter form molex to SATA.
-----------
My plan is to try to get the systems fans to be at the lowest speed ,before triggering the low critical thresold around 2100 and increase the speed when temperature increases.
***I'm not responsible of any damage done to your system, proceed at your own risk****
***Remember to check on the temperatures, it works for me but maybe it does not for your system***
If you use a text compare with the 2 files you can see the changes on the Global Step Curve
Extract the file...
I have managed to get the FANS down, but I think I can still tinker a bit more with the settings. I need to figure all the sensors and the differente curves to see to which fan applies, because with the current settings the PSU fans are louder, I think I have increased their spinning.
I will...
Thanks, I´ll try to update the FRU and see If I can get the FANs to slow down. Then I´ll try with the SDR to change to global stepcurve to slow the fans.
Hello, I purchased one of this servers and while trying to update the SDR file to custom settings to lower the RPM fans, I messed up and I lost the FRU information, so now the fans are worse than before, as it´s not detecting the right hardware.
Could anyone share with me a picture of theirs...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.