Curious, what CAD and simulation packages are you running?
I'm leaning toward you really should build a dedicated solver rather than try to run both solving and workstations on the same machine(s), it works but if you try going really intense with either it could end badly. Unless you do like...
Using Sound Meter on my phone I got 75 - 80 dB when first turning on / fans at full, and 55 - 60 dB at idle, though since the phone isn't calibrated that should be taken as a ballpark. Not sure on power consumption, don't have a Kill A Watt yet.
ADDED: Should note this is for a single 2ML, not...
That's exactly what has me concerned, the rails are 2mm thick and 165.8mm long, there's a high potential for failure with the suggested printing method.
Hey guys, been lurking for about a month and finally joined, have a bit of 3D printing experience so might be a bit of help here.
I personally would not print the part as it is, there's enough going on that printing it would require a bunch of support material and may not come out well. If...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.