When I followed the guide, I would get the following error:
ICX77xx-Boot> update_uboot
Updating BOOT image over TFTP
Using FM1@DTSEC1 device
TFTP from server 192.168.1.2; our IP address is 192.168.2.2; sending through gateway 192.168.2.1
Filename 'ICX7xxx/spz10118.bin'.
Load address: 0x1000000...
I ran the u boot update again and reset the switch. The version is now 10.1.18. I ran into the same issue for the primary update where I'd get the "Primary image download failed". I think this had to do with my tftp server timing out. Rather than spending hours trying to diagnose, I just used...
Just received a new (to me) 7250-24p. Walking through the setup guide, the uboot image updates just fine, but the primary image fails.
All I get is:
ICX7250-Boot> update_uboot
Loading image to Uboot Partition 1
Using bcmiproc_eth-0 device
TFTP from server 10.22.102.17; our IP address is...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.