Search results

  1. M

    1U Supermicro Server 6x 10GBE RJ45 X10SLH-LN6TF LGA 1150 H3 X10SLH-N6-ST031

    I do get a little beep, yes. I don't get the 5 beeps that would indicate a RAM error. It's ECC non registered. PC3L-12800E
  2. M

    1U Supermicro Server 6x 10GBE RJ45 X10SLH-LN6TF LGA 1150 H3 X10SLH-N6-ST031

    Thanks eduncan. The seller reset the bios on mine before shipping. But I took out the CMOS battery and it reads 3.012V. I put it back in and booted. Same thing. I can get beeps out of it if I remove the RAM. Five short, One long, like it says in Appendix A of the manual. I've already...
  3. M

    1U Supermicro Server 6x 10GBE RJ45 X10SLH-LN6TF LGA 1150 H3 X10SLH-N6-ST031

    I received one of these, installed a CPU and RAM. No beeps. But also no VGA signal. Checked JPG1 jumper and it's on 1-2 (enabled). Seller reset the IPMI user/pass but didn't write down the IP address. If I can't get into the BIOS, do I have to run a DHCP server and provide it an IP address...
  4. M

    A bunch of Juniper SRX300 firewalls dumped cheap

    Finally received the unit and found time to wire an RJ45 serial cable which only took me three tries. I'm running JUNOS 12.3X48, specifically: JUNOS 12.3X48-D70.3 #0: 2018-05-17 09:31:28 UTC Trying to reset the root password and will send a PM.
  5. M

    A bunch of Juniper SRX300 firewalls dumped cheap

    I hope it's not offside to resurrect this thread, but I just bought a SRX 650 and am wondering about buying core care coverage. Based on the manufacturer's part number for the SRX300 that was posted above, I went looking on CDW. There's 1 year of core care on CDW for $1238 but that's a bit...