I have no equipment to plug the fiber in (yet), that's why I wanted to try to force it up. Apparently on some device, you can connect to it, even with no fiber plugged in it. I'll look at the link you provided and try to eventually solder it if needed. Thank you.
Edit: I tried with another old...
It's a Nokia/Alcatel G-010S-A. When I plug it in my ICX it stays down.
SSH@leswitch#show run interface ethernet 1/3/4
SSH@leswitch#
no conf on port just untag Vlan, and port stays down:
SSH@leswitch#show interfaces ethernet 1/3/4
10GigabitEthernet1/3/4 is down, line protocol is down
Port...
Hello, I have a GPON SFP and I'd like to connect to it via its internal IP, for testing purposes (how to backup partition, flash it, etc.)
Problem is that I don't have anything (equipment to connect the fiber) to plug in it for the moment. On old Cisco switchs I remember that there was a no...
I have a dumb question: is the boot time of the ICX affected by the number of Lan declared inside the switch ? I have had at home a TP Link TL-SG3424. One day after a power failure, my switch didn't boot. I thought it was dead, but in fact it eventually boot but in 40 minutes. I had made trunks...
Hello,
Long time lurker, first post here. I pulled the trigger for a 6610-24p, and I'm currently on page 60 out 210, keep reading 'til the end ;) Thanks @fohdeesha for you work here !
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.