I was hoping Cisco was a little smarter and I could drive 6 switches with the two PSU's taken care of failover o_O
I have 2 x 1150 watt psu and each can only drive ONE of my 50-60 watt switches - this is waste of resources and rackspace.
This means that a failure in the primary power...
Thank you very much for clarifying :)
I have tested and my switches does not need to be rebooted to switch back to on-board PSU.
But I have seen schematics where multiple switches are driven from one RPS 2300.
The image below shows 1x POE and 5x non-POE switches.
From documentation:
Cisco...
I was hoping that some one would have experience with the Cisco RPS 2300 redundant power supply unit.
I have a RPS 2300 and 2 x 1150 watt PSU installed.
There is 2 cisco switches connected.
I was of the impression that I could remove the power to one of the PSU's and then it would fail over...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.