I have an ICX-6450-24P that I have been using without issue for a few years. Recently after a power outage I discover that not only was my UPS no longer working, but the switch didn't power itself back up when the power came back on.
After unplugging it, waiting about 5 seconds and then...
Has anyone configured a vlan for a a guest wireless network from a unifi AP? I am a bit lost as the implementation is of course way different than the Zyxel that it is replacing..
This is how I acomplished it on the Zyxel.. vlan2 is what I am using for the guest network
EDIT: I figured it out...
Does anyone have a 10gig Ethernet transceiver that they recommend for the 6450?
I would go with just dac cables but my board already has dual 10g Ethenet.
Well the fans I ordered from Digikey are only 2-wire and don't have the connector. #facepalm
Can anyone confirm whether these need the RPM type output, or the RD output (rotation detection)?
I thought I read here that the Noctuas wouldn't start at the lowest fan level 4.5v?
I was also under the impression that it needed the locked rotor detection.
I might, I haven't gotten that far with mine yet.
I did find and order a suitable set of fans.. These are 7.7CFM @ 21DB, have the RD output and best of all available from a reputable seller.
MF40201V2-1000U-A99 Sunon Fans | Fans, Thermal Management | DigiKey
So I did some testing on my 6450 last night with the replacement sunon fans and something is amiss.
The more I look at it, I think these might be knock-offs.. they make a sound almost like old hard drive would.
Comparing the one I am holding to a used one I found on ebay, the ones that i...
I got my icx6450-24p today, but my console cable won't be here until next week.. I take there is not really anything I can do until I get that?
A fan mod is definitely in the pipe for this thing,, I think the fans may actually failing as they have more of a high pitch ring than I was expecting.
Just scored an ICX6450-24p for $150 shipped on ebay.
I'm excited to get it and play around with it.. it does seem to have the QR code sticker that I have seen mentioned here a few times:
Brocade ICX6450-24P 24-Port Gigabit PoE Switch Tested Working | RNW3354DS-U | eBay
Thanks for all the input here.. it sounds like the ICX6450 is the better choice.
The tinkerer in me wonders if it's possible to design a circuit for fan control to convert the 4.5 -12v into a pwm duty cycle %.. thus allowing the use of the noctua 40mm x 20 fans.
First-time poster, long-time lurker here.
I am looking at replacing my Zyxel GS1910-24 with something that has both 10G uplinks, and POE. The kicker is, I don't really need any of the L3 features, I would rather leave all the VLAN config in my Pfsense box.
I would really also prefer to use...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.