Search results

  1. F

    Is it possible to get these SAS Hitachi drives to work on a "normal" system?

    Read this document point 7.0 https://www.seagate.com/staticfiles/support/disc/manuals/enterprise/savvio/10K.4/100539221c.pdf About self-encrypting drive, I think this applies to HGST DKR5C. If the disk is encrypted, it goes into read-only mode.
  2. F

    Is it possible to get these SAS Hitachi drives to work on a "normal" system?

    This will not work, the data in the flash only for the initial download main firmware is stored on magnetic disks.
  3. F

    Is it possible to get these SAS Hitachi drives to work on a "normal" system?

    Yes, is the maximum amount of ROM disk. Macronix MX25U4032E
  4. F

    Is it possible to get these SAS Hitachi drives to work on a "normal" system?

    using the programmer directly from the memory chip flash
  5. F

    Is it possible to get these SAS Hitachi drives to work on a "normal" system?

    there is a dump of the firmware B8B8 for DKR5D where to send?