Yeap just ordered a console cable, seems as that is going to be the way I can get back into the switch. Thanks for your suggestions..
Update: Console cable resolved the issue.
Thanks for the reply and I did look at those instructions, but a far as I can tell the commands can only be executed via the console port. If I try to SSH it is asking to login.
Hi All
Have had the ICX6610-48P running fine for ages. Decided to upgrade to the latest firmware(8030u) and bootloader as I was having problems with PoE. Firmware upgrade went all ok, but now I can not log into the web gui. I can get to the web gui via an ip address but it does not accept the...
Thanks to this forum and fohdeesha, I have installed my converted 649281-B21(now a MCX354A-FCBT) Network card in my QNAP NAS and connected it at 40GbE via the Brocade ICX6610-48P. I am using the NetApp 112-00178 X6559-R6 External SAS Cable to connect the two devices.
Still running tests on...
Just wanted to say thanks to fohdeesha for lots of great info. I picked up a 6610-48P with the ICX6610-PREM-LIC-SW for my homelab. Looking to setup a 40GB connection between the switch and my NAS. Do I need to purchase a 40GB specific license for this switch or does the Icx6610-10g-lic-pod...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.