The firmware is brain dead. I neutralized the pwm cable to have the fans running at 100%. Hmartin made a mod to control his fan manually with a little pwm controller that you can find online for a few bucks.
My cpus are v1.
Envoyé de mon SM-A320FL en utilisant Tapatalk
The PSU is a separate board when you have a dual node and there are also fan connectors on the board. This what I have.
You should look at the mod of hmartin for single board...
Did you look here? May be it could help. Server/SpecsAndDesigns - OpenCompute
Intel Xeon server v2 cad (dxf) files.
HTH
Envoyé de mon SM-A320FL en utilisant Tapatalk
For cryptonight-lite
With no option at all. The hash rate is swinging between 2.6 and 2.9k. Do you know why it is swinging?
-v 2 => 2.9k stable
-v 2 --doublehash-thread-mask 0xF0F => 2.5K stable
-v 2 --doublehash-thread-mask 0x707 => 2.4 stable
Actual xmr-stak => +3K (AES-NI, Hugepages, no...
Hello
I tried your miner and wanted to compare the results to xmr-stak.
To make a fair comparison could you tell me how I can reproduce this config in your miner:
Tks
At least I found a solution to have the fans at 100%. I neutralized the PWM cable on one CPU Fan. The board detects it as failed and it delivers 100%. Lol.
I also found these raw ipmi queries, but I cannot see what they do.
ipmi-raw 0x00 0x30 0x30 0x00 0x00
ipmi-raw 0x00 0x30 0x31 0x00
I already tried to update the ME using their tool but it aborted: ME Update Read Data from ff000000 Not Match Retry.
I aborted the stress test at 78C. Throttling is not an option. I need heavy load 24/7. Intel specs give a limit of 73C.
I swapped the heatsinks with noctua ones and quiet fans...
Hello,
I found this technical manual and it mentions an FSC Image Update procedure (page 203).
https://www.serverware.com.my/media/product_downloads/X300/Rackgo_X700_Manual_0528.pdf
Could somebody share the flashtool and the files if any?
There is also a note about flash recovering the ME...
Hi,
I have the BIOS ver F03C3A07 and I don't see any options to control the fans (profile).
The CPU fans are not ramping up when the CPU temp is higher.
I already tried to change the fans and Px Therm Margin threshold through dcmi but it does not change anything.
It triggers an event but...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.