Search results

Just as a follow up on working SFP+ transceivers for the Delta Networks ET-DT7024 24 Port 10GB SFP+ 4 x10GBase-T Layer 3 Switch that has been changed into a Dell PowerConnect 8024F running firmware 5.11.1.1. I finally found a SFP+ transceiver that works, FTLX8571D3BCV-IT.

Just as a follow up on working SFP+ transceivers for the Delta Networks ET-DT7024 24 Port 10GB SFP+ 4 x10GBase-T Layer 3 Switch that has been changed into a Dell PowerConnect 8024F running firmware 5.11.1.1. I finally found a SFP+ transceiver that works, FTLX8571D3BCV-IT.

@paulsa ... thanks for the info, I'll get them in my next order.

@paulsa ... thanks for the info. This Delta Networks ET-DT7024 24 Port 10GB SFP+ 4 x10GBase-T Layer 3 Switch with Dell PowerConnect 8024F firmware 5.11.1.1 likes just about any DAC I use, but I haven't found a SFP+ that it will accept. I'll give the generic FS SFP+ a try.

@AFisher ... just as a followup, did the 407-10356 10GBASE-SR SFP+ Transceiver work with the Dell 8024f ? I have tried several different SFP+ transceivers, 331-5311, E10GSFPSR & 407-10356 and all have failed to work in my Delta Networks ET-DT7024 24 Port 10GB SFP+ 4 x10GBase-T Layer 3 Switch...

@Terry Kennedy ... Thanks for info, here are my results from the fiber-port optical-transceiver command. I received the same results from all three brands of transceiver. Concerning the dev cpldTest command, I used a cable as you suggested. The results look similar to yours, I was using port...

I bought a Delta Networks ET-DT7024 24 Port 10GB SFP+ 4 x10GBase-T Layer 3 Switch with Dell PowerConnect 8024F firmware 5.11.1.1 which is working as expected. I use it with 10G DACs, but have a need to use fiber because of range. I have 3 different types of FS.com recommended 10G SFP+...

@Joe McGuckin list of known show commands show port-channel all show tech-support show run show ver show sysinfo show clock detail show bootvar show arp show class-map show clock show dos-control show dot1q-tunnel show dot1x show dvlan-tunnel show eventlog show garp show hardware show hosts...

Be sure to use PC8024v5.1.11.1.stk after the tftp try using bootm 0x8000000 or go 0x8000000