7150 has no fan. It feels warm outside not hot. I recently replaced the broken 7150 power supply with a MeanWell one and a fan because the MeanWell power supply provides fan power.
I have another broken 7150 which constantly prints
" "PoE Fatal: Vmain (48V) fault has forced all ports on...
The cert and keys are stored in a ubifs volume mounted as /opt
mount -t ubifs -o sync ubi1:resources /opt
I got this from a bad update:
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
Resources partition is...
That was a DES encrypted password with salt.
openssl passwd --crypt --salt=wY --stdin <pswd
where pswd contains the default barcode password, see attached file.
He rejected my offer at $40 and jacked up list price. Here's a supplier from HK LB130S56K | Ault / SL Power LB130S56K Stock available from Infinite-Electronic.hk | LB130S56K with Best Price at Infinite-Electronic.hk .
After a failed flash attempt on icx7150, the next boot says the flash is to be reformated and device keys deleted. The following command fails:
SSH@ICX7150-C12 Router(config)#dm verify-device-certs
Commencing sanity check for device certs ...
Verifying TPM files ...
Failed: Check TCSD_PS...
I have been using this board with six HGST 10T drives for about five months. After a recent addition of Intel Optane 16G M.2 drive to the board, I am getting SATA reset on all the drives. Removal of the Intel M.2 does not change anything.
ata15: link is slow to respond, please be patient...
I got two Brocade XBR-000232 QSFP 57-1000267-01 4*16Gb. When I plug them to 6610 breakout ports, show media displays it as 40GBASE-Passive Copper with or without fiber. I am using this Plenum MTP MPO to 4LC Fiber Optic Breakout Cable, OM3 50um, 3 Meter | eBay . This has a male connector. I...
I got a 2x M.2 board from them. The card did not work. One port shows pcie errors. Their tech support is awful, keeping asking from the same information.
Anybody uses QPF+ to SPF+ convertor on the LB6M?
I cannot ping Mellanox Connectx-3 VPI HCA through the convertor.
But direct connection of two SPF+ ports via DAC works.
The MAC address of the Mellanox port is displayed with
show mac-addr-table on the switch. I have no idea why I cannot ping it.
Hi,
I have trouble updating the firmware.
All nvmupdate versions from intel say update is no available.
ethtool -i ens4f1
driver: i40e
version: 2.0.19
firmware-version: 4.10 0x800011c5 0.0.0
expansion-rom-version:
bus-info: 0000:02:00.1
supports-statistics: yes
supports-test: yes...
Anybody knows how to enable management port two? telnet to port 2323 and log in as root; I see eth0 and eth1. eth0 is management port one.
I give eth1 an ip but can only connect to it from management port one jack.
I use this one Amazon.com: Gopala 6 FT FTDI Chip USB to RJ45,Usb Console Cable for Cisco Routers: Computers & Accessories
and
screen /dev/tty.usbserial-A105YGJZ 9200
to connect to the switch on a mac.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.